Torsion Bars

[AlastairCooke]

Hi All,
I am starting to assemble the torsion bars. (Another task I can do whilst waiting for the weather to improve so that I can begin a final disassembly and etch prime). I carefully reworked the threads so that I could hand tighten down to the state shown below. Is this sufficient or should the 'shoulder' not be visible. I cannot tell whether I have bottomed out the tread or not.

Any advice or guidance would be appreciated, thanks.

Alastair

[Vince Cutajar]

From those photos it looks like the steel shafts have bottomed out to the faces of the swing arm so that is as much that they will go in.

Vince