Hi,
A few pics of my Sherman originally built by Chris Fry and it's as good today as it was when he sold it seven years ago...great job Chris
Cheers
Sherman
-
- Posts: 651
- Joined: Fri Aug 29, 2008 5:04 pm
- Location: Seaford East Sussex
- Has liked: 149 times
- Been liked: 660 times
-
- Posts: 155
- Joined: Wed Aug 28, 2013 3:03 pm
- Location: Catlettsburg, Kentucky USA
- Has liked: 224 times
- Been liked: 181 times
Re: Sherman
WOW David! That looks GREAT! There's sure been a LOT of detail work put in it!!
How do those 'Duckbills' on the tracks hold up? I've been curious about'em but don't know how sturdy they'd be.
Mike
How do those 'Duckbills' on the tracks hold up? I've been curious about'em but don't know how sturdy they'd be.
Mike
Armorteks: King Tiger, Tiger 1, Panther G, Panzer IV, M4A3 Shermans x2, M3 Lee, Pershing, Sd Kfz 7, Pak 43.
-
- Posts: 651
- Joined: Fri Aug 29, 2008 5:04 pm
- Location: Seaford East Sussex
- Has liked: 149 times
- Been liked: 660 times
Re: Sherman
Hi,
I've had no issues with the duckbills and would recommend fitting a set. They can become bent up if driving over obstacles but easily manipulated back into original position.
Cheers
I've had no issues with the duckbills and would recommend fitting a set. They can become bent up if driving over obstacles but easily manipulated back into original position.
Cheers
-
- Posts: 250
- Joined: Sun Jul 15, 2007 2:54 pm
- Location: USA
- Been liked: 48 times
- Contact:
Re: Sherman
Chris got the duckbills from me years ago. They were made from sheet metal and represent the slip on pattern and are held in place with the tooth connecting bolt which needs to be drilled by the user. I always wondered how they would hold up with use since I never designed or used them on an RC tank.
And true to form the slip on types did bend very easily and were much weaker than the cast pattern duckbill
They are still listed on the catalog but are a real pain to fabricate. I was thinking about removing them due to the hassle of fabrication, or possibly material swapping them for printed units. The white material might be able to hold up but I would need to do some R&D before hand
And true to form the slip on types did bend very easily and were much weaker than the cast pattern duckbill
They are still listed on the catalog but are a real pain to fabricate. I was thinking about removing them due to the hassle of fabrication, or possibly material swapping them for printed units. The white material might be able to hold up but I would need to do some R&D before hand