PAK 43 2018 arrived in Denmark

Allan Carlsen · Post by **Allan Carlsen** » Thu Feb 28, 2019 8:35 pm

Hello guys

Need some help. I'am working with lower shield. The instructions book does not tell exactly how to put lower shield to front of CNO109.

I have use M3 x 6 button to attach lower shield to the front - 3 qty - is this ok ?

or should I use some others bolt or screw ?

Tom Roslund · Post by **Tom Roslund** » Fri Mar 01, 2019 6:21 pm

Allan, I think I used the Knupfer small head 3mm hex head screws here. With the Armorpax kit , you have to make a larger lower shield that is more accurate, and accommodates the shovel mountings. These smaller screws allowed more swing for the shield as well. The RC scale crawler world has some nice fastener options that help the look as well. I think the bolts on the fixed shield above are those.
Tom

Allan Carlsen · Post by **Allan Carlsen** » Sun Mar 03, 2019 6:43 pm

Hello Tom

thanks for answers and tips/picture.

According to the drawing page 11, it says M2.5 x 5 rnd hd. Maybe I will use your small head 3mm hex head screws instead

Allan Carlsen · Post by **Allan Carlsen** » Fri Mar 08, 2019 6:43 am

Good morning everyone

Now I am 99% finished and have been through all the pages in the manual

There are now some errors that need to be corrected

The shield is loosely attached and the gunsight must be properly attached (have to move shield and other Things)