Tiger 131 drive control question

[John Grima]

Hi everyone, currently I'm getting the radio mounted / calibrated to the tiger 131 w/ 2016 motion pack. When I hook everything up to the radio the two front sprockets run at full throttle uncontrollably. When I connect a simple servo to these same channels they work fine.

I remember encountering something similar to this on the elevation on my last build and to fix this I had to throw a dip switch. Do I need to do something similar with these channels too? I just wanted to ask on here before I go and tamper with anything

For the radio my specs are listed below,

Futaba 14SG 2.4ghz
https://www.futabarc.com/systems/futk9410-14sg/

any help would be of great use. thanks John

[Adrian Harris]

What receiver do you have and do you know which mode is being used (FASST or S-FHSS) ?

Adrian

[John Grima]

on the RX it has FASST on the label. As for which setting is on the radio... I'm not sure I want to say that it is at the stock setting as I just opened the packaging.

[Adrian Harris]

Sounds identical to the issues here:

viewtopic.php?f=37&t=6700&start=15

Adrian.

[John Grima]

Yes that looks to be the exact problem. I went ahead and sent the radio back in place for a different unit. The unit I had was a bit overkill for what was needed. Thanks again.