turret limit switches

Ray Brown · Post by **Ray Brown** » Mon Sep 23, 2013 10:46 am

g'day guys. does anybody have some pictures showing the limit switches for the elevation & depression mounted in the tiger 1? the pictures below are were i'm at. as they say, a picture says a zillion words....

cheers
ray

Malcolm Collins · Post by **Malcolm Collins** » Mon Sep 23, 2013 11:26 am

Hi Ray, Here is a picture of the set up in my Tiger. This is not a tank I built but I hope it helps you with your set up.
Best regards
Malcolm

Dennis Jones · Post by **Dennis Jones** » Mon Sep 23, 2013 1:33 pm

Hi Ray,

Here are photos of my install including a counterbalance weight on rear of barrel.

Dennis.

Post by **Armortek** » Mon Sep 23, 2013 3:18 pm

Hello Ray

Malcolm's set up is the design that was used on older models. Dennis has made his own bracket up as a special. On your model the limit switches are designed to fit on either side of the recoil bracket. Holes and fasteners are provided in the kit. You can see the three holes in the illustration in your motion pack instructions, but we have omitted to tell you they are for the limit switches. Once in place the arms can be bent to act against the floor for max elevation and the roof for min.

Regards
Mark

Ray Brown · Post by **Ray Brown** » Tue Sep 24, 2013 2:10 am

thanks guys. will check it out.

cheers
ray

turret limit switches

turret limit switches

Re: turret limit switches

Re: turret limit switches

Re: turret limit switches

Re: turret limit switches