Hello to all.
Slowly, I try to take forward work on my Panzer III.
After that I painted the base colors of the various parts, I started to assemble the torsion bars and suspension arms.
In the meantime, I have prepared the rear supports for the side fenders.
I used a profile of brass "U" shaped, cut and welded.
As you can see, the last brass supports were mounted lower than the other media, so that the side fenders curved line will follow the same track as the real Tank.
Once assembled the whole thing, we painted the interior with ivory white.
The hull is then ready to receive the electronics and batteries.
In the meantime we have moved to the side fenders, which have been cleaned and painted with primer.
The five sections were sawed in the outer part is to simulate the separate sections of the fenders true, both to facilitate the bending of the various sections.
Then were placed the various plates of brass almond, that were first bonded and then pierced and riveted.
As you can see, the fourth sections of the fenders were modified as in the real Panzer for the presence of the side air intakes of the upper hull.
This change is necessary because the fenders are slightly raised with respect to the location of the kit.
As always, I will apologize for my bad English: I hope you will forgive my mistakes!
Until next time!
