When I display my P IV not all organosors allow you to run your model at the show and I am often asked will it "go" by vistors.
So I made this plate jack to lift the tracks off my hydraulic display table to allow them to turn without moving the tank forward/back.
Its about 24" long x 8" wide, just fits under the belly of the tank and lifts it approx 3/4".
It looks a bit rough because its made from whatever was to hand ie the base and side struts were from an old desk.
RUNNING TRACKS ON DISPLAYS
-
- Posts: 247
- Joined: Mon Jul 16, 2007 11:15 am
- Location: BRIXHAM
- Has liked: 2 times
- Been liked: 15 times
-
- Posts: 377
- Joined: Sat Apr 03, 2010 3:23 pm
- Location: Welshpool, Powys