Started with the system power switch. Drilled the little hole for the external tab washer in the little box thingy the switch mounts in. Then some off the shelf angle for a couple of brackets.
The fixings go right through the box with locknuts on the other side.
Then marked its position under the deck keeping it parallel to the filler cap mountings.
Then marked and drilled fixing holes.The correct length fixings will be used on final assembly.
Had a slot machined in the filler cap with plenty of clearance for the toggle sticking through the deck.
Just enough toggle sticking through to operate. Some little stickers for once it has all been painted.
That is that one completed.
Then made a top hat bracket for the smoke unit switch.
Slot drilled and filed for the switch.
Mounting holes drilled and painted.
Hole punch used to enlarge existing hole.
Nibbed off the sharp edges on the new hole then mounted the switch like so.
Thank you for the comments Derek and Bob. As you say Bob they could be used for charging sockets, another good idea. I am hoping if all goes to plan, which it sometimes doesn't, to put a main battery isolator and charging sockets under the front hatches. And the middle filler cap on the rear deck will be the fill point for the smoke unit, hopefully. I need to confirm what thread is used for the filler tube on the smoke unit before I do that but busy on other things at the moment.
