I'm looking at refurbing one of the recent Panther kits and wondered if anyone had looked into making the rear deck removable in one piece ?
Looking at the manual, I'm wondering if CH0154 could be mounted to the deck, rather than the hull sides, and then have something installed onto the hull sides to support the deck. At the moment, the four cast vents at the corners are only supported by their inner ends, via CH0153, so flap around when the deck is removed.
Adrian.
Removable rear deck
- Adrian Harris
- Posts: 5016
- Joined: Thu Jul 12, 2007 10:46 pm
- Location: Berkshire (UK)
- Has liked: 1296 times
- Been liked: 1511 times
Removable rear deck
Contact me at sales@armortekaddict.uk for details of my smoker fan control module
- William Gardeniers
- Posts: 213
- Joined: Fri Jul 24, 2009 5:38 pm
- Location: Netherlands
- Has liked: 44 times
- Been liked: 264 times
Re: Removable rear deck
Hello Adrian
I did it with the rear deck off my Bergepanther , but this was with the universal hull.
I did it with the rear deck off my Bergepanther , but this was with the universal hull.
With Regards William
-
- Posts: 168
- Joined: Mon Jul 23, 2007 9:51 pm
- Has liked: 104 times
- Been liked: 230 times
Re: Removable rear deck
Hi Adrian
I'm not totally familiar with the differences between AT's later panther models construction, but for info the rear deck on my 'A' is not screwed down and can be lifted out without removing the center deck or turret. I've never found a problem with the cast grills moving about, are you able to tighten them up more, if not maybe there's some scope for some small brackets to fix the 'free' ends to the engine deck?
David
I'm not totally familiar with the differences between AT's later panther models construction, but for info the rear deck on my 'A' is not screwed down and can be lifted out without removing the center deck or turret. I've never found a problem with the cast grills moving about, are you able to tighten them up more, if not maybe there's some scope for some small brackets to fix the 'free' ends to the engine deck?
David